SunGlo (700 Series) Modified Alkyd Enamel

---

		DESCRIPTION
		SunGlo is a high quality Modified Alkyd Enamel with excellent coverage, gloss, and durability. It may be applied with or without hardener.
		COMPONENTS
		* SunGlo 700............. Color * 142........................... Medium Reducer * 700C000................. Hardener * 143........................... Slow Reducer * 141........................... Fast Reducer * 144........................... Very Slow Reducer
		MIXING RATIO
		Reduce 10-20% with 141-144 Reducer With Hardener: 8 parts color to 1 part 700C000 Hardener.
		POT LIFE @ 77° F
		Indefinite without 700C000 hardener 6 Hours with 700C000 hardener
		CLEAN UP
		Valspar Refinish 100 Thinner (Check local regulations)
		ADDITIVES
		ACCELERATOR............. N/A FISHEYE........................... T152 1 oz per gallon. FLEX ADDITIVE.............. N/A NOTE: Do not spray when surface temperature is below 50 °F.
		SURFACE PREPARATION
		USE RECOMMENDED UNDERCOAT SYSTEM FOLLOWING RECOMMENDED PROCEDURES. * Finish sand with P360 grit wet or dry sandpaper or equivalent. * Mask vehicle thoroughly if panel repairing.
		SUBSTRATES
		* AquaPrime 9 * SupaFil 96N/21N * VP Series Epoxy Primers * SunSeal 82 * SunFil 92 * SupaSeal 97N * 87N * ColorFil 092 * Properly Prepared OEM Finish
		APPLICATION
		* Spray two to three medium wet coats allowing 20 minutes between coats.
		FLASH/DRY TIMES
		AIR DRY @ 77 °F Flash between coats........................... 20 Minutes Tape Time without Hardener.............. Overnight Tape Time with Hardener................... Overnight To Deliver............................................. Next Day FORCE DRY Flash before Force Dry...................... 20 Minutes Force Dry Time................................... 30 Minutes @ 140 °F To Tape................................................ After Cool Down (1 - 2 Hours) To Topcoat........................................... After Cool Down (1 - 2 Hours)
		GUN SETUPS
		CONVENTIONAL Gravity Feed........................ 1.6mm - 1.8mm Siphon Feed........................ 1.6mm - 1.8mm HVLP................................... .043" - .052" AIR PRESSURES Conventional @ Gun -------- PANEL ----------- OVERALL Gravity Feed........................ 30 - 35psi .......... 35 - 40psi Siphon Feed........................ 30 - 45psi .......... 40 - 50psi HVLP @ Cap....................... 6 - 8psi .............. 8 - 10psi
		PHYSICAL DATA
		VOC (Unreduced)................ 4.2 - 4.5 lbs/gallon Volume Solids...................... 34.0-36.0% (Average) Theoretical Coverage......... 530-584 sq ft per mil per gallon Flash Point............................ 52 °F
		SAFETY
		Before using any Valspar Refinish product, be sure to read all MSDS and application instructions and warnings. Always wear a properly fitted air purifying respirator with organic vapor cartridges and particulate filter or a fresh air respirator(depending on product selection), eye protection, gloves and protective clothing during application and until vapors are exhausted. Do not permit anyone without protection in the painting area. This product is intended for use by a professionally trained painter. Keep out of the reach of children.